Cleat Flooring Nailers
Cleat flooring nailers help install cleats into hardwood floors and make wood flooring for beginners easy. These air nailers can usually double as a stapler and most of them are highly durable yet lightweight.
There are many cleat flooring nailers for sale and come with different types of staples and cleats. Take a look at our cleat flooring nailers below for more information:
Cleat Flooring Nailers: Operating and Troubleshooting Tips
Cleat flooring nailers are the perfect power tools specifically designed to accurately drive L-shaped floor cleats for just about any job site – from your home down to major constructions. If you are specifically checking online, make sure that the cleat flooring nailers inventory is delivered accordingly. Make sure that your nailer inventory includes the flooring nailer, oil, safety goggles, base plate, hex wrench (both in four and five millimeters), and hammer. Now that your cleat flooring inventory is complete, you could now start working on your project with this guide.
Set the compressed air system. This is the ultimate power source for most cleat flooring nailers model. Make sure that you would not exceed 120 psi – the maximum operating pressure for just about any model. Before using the nailer, first set the pressure to 60 psi.
Assemble filter-lubricator-regulator and place it close to the nailer as much as possible. This tool would care for your nailer by preventing water and moisture build-up and even save you from the inconvenience of lubricating the nailer in your every use.
Check the firing mechanism. Properly working cleat flooring nailers would not fire unless you hit the “whack cap” with a mallet. To see if the firing mechanism works properly, first, remove the nailer from the air supply. Then, check the magazine if it is empty and had not been loaded. And, lastly, carefully place the nailer on the ground and, then, connect it to the air supply. If the nailer fires when you hit the whack cap, then, the firing system of the nailer is working properly. If it didn’t OR it has fired immediately after you have connected it to the air supply, contact your retailer or manufacturer.
Oiling the nailer. It is not only important to keep the water off the nailer but also to provide it with the required moisture by supplying pneumatic oil (that is basically required to be included in all cleat flooring nailers inventory). Simply apply four drops of oil in the air inlet before you fire up the tool. Clean the excess oil to prevent dust build-up. Purchasing a filter-lubricator-regulator saves you from manually lubricating the nailer every day.
Troubleshooting Tips for Cleat Flooring Nailers
Loss of power or if the tool runs slower, you would want to check the air pressure for possible blockage. If this does not work, check the exhaust cap and the driver. A build-up of dirt, oil, and water could lead to the slow firing of nails.
Skipping nails when discharged is a possible result of a number of issues. Check the following parts: the magazine for a possible blockage, O-rings, bumper, pusher spring, and a damaged driver. Replace parts that had been worn to fix the problem.
Fasteners jammed the nailer. Three things that are needed to be checked on cleat flooring nailers: the nails, magazine screw, and the driver. Using damaged and even dirty nails could cause the problem. Replace worn or damaged driver or tighten the magazine screw to repair the nailer.